E1

Houghton Air Conditioner: “E1”

warning RV air conditioner error codes

Safety Disconnect shore power and the AC breaker before opening any control or ceiling assembly; these units run on 120V mains.

What it means

The room-air temperature sensor is reading as out of range, shorted, or open, so the unit cannot measure cabin temperature.

Most likely causes

  1. Disconnected or damaged room temperature sensor wiring most likely
  2. Failed (drifted/shorted/open) room temperature sensor common
  3. Control board input fault less common

Safe checks you can do yourself

How to reset / clear E1

  1. Turn the unit off and remove power at the breaker for about a minute.
  2. Restore power; if the sensor connection is good the code should clear.

When to call a technician

If reseating the connector does not clear the code, the temperature sensor or control board likely needs replacement by a technician.

Applies to

Houghton Belaire 3400 · Houghton Belaire 3500 · Houghton Belaire 3800 · Houghton Belaire series rooftop AC

FAQ

What does Houghton Air Conditioner code "E1" mean?

The room-air temperature sensor is reading as out of range, shorted, or open, so the unit cannot measure cabin temperature.

How do I reset Houghton Air Conditioner E1?

Turn the unit off and remove power at the breaker for about a minute. Restore power; if the sensor connection is good the code should clear.

What is the most common cause of E1 on a Houghton Air Conditioner?

The most likely cause is disconnected or damaged room temperature sensor wiring.

Related · Houghton air conditioner

Note: On some Houghton units the primary room sensor sits at the wall pad (see E9); E1 refers to the room-temperature sensor circuit.

Last verified 2026-06-29 · compiled from manufacturer documentation. Codes can vary by model year — always cross-check your unit’s manual.