RV leveling system error codes

Automatic leveling systems display messages when they cannot complete a level, hit a stroke limit, lose communication, or sit on too steep a slope.

Lippert

Bad Calibration
The controller's stored level-sensor calibration values are outside the acceptab… Comm Error
Communication between the touchpad and the control module has been lost. The tou… Excessive Slope
The RV is parked on ground that is too far out of level for the system to safely… External Sensor Error
The controller lost a valid reading from the external (rear) level sensor, which… Feature Disabled
Shown during Hitch Recognition (unhitch) on fifth-wheel units when the front of … Internal Sensor Error
The level sensor built into the leveling controller itself is reporting bad or o… Jack Position Fault
An error at one specific jack on the Ground Control 3.0 electric system, identif… Jack Time Out
A jack motor pulled an unexpectedly high current (a stall) or did not complete i… Low Voltage
Battery voltage dropped too low for safe operation. On the Level-Up system, auto… Out of Stroke
A jack has run out of travel before leveling could be completed. The jack reache…