Lippert Leveling System: “Feature Disabled”
info RV leveling system error codes
What it means
Shown during Hitch Recognition (unhitch) on fifth-wheel units when the front of the trailer is below level — typically because the landing gear was not fully retracted before starting — so the automatic hitch feature is blocked.
Most likely causes
- Landing gear not fully retracted before starting Hitch Recognition most likely
- Front of the trailer sitting below level when the routine begins common
Safe checks you can do yourself
- Use manual mode to fully retract the rear jacks
- Raise the landing gear / front so the nose is at or above hitch height
- Confirm the pin box is roughly at the correct hitch height before retrying
How to reset / clear Feature Disabled
- Switch to manual mode and reposition the front to hitch height
- Exit and re-enter the Hitch Recognition / auto routine
- Proceed once the front is at or above level
When to call a technician
The feature stays disabled even when the front is correctly positioned at hitch height — indicates a sensor or controller issue.
Applies to
Ground Control 3.0 (5th wheel 4-point and 6-point)
FAQ
What does Lippert Leveling System code "Feature Disabled" mean?
Shown during Hitch Recognition (unhitch) on fifth-wheel units when the front of the trailer is below level — typically because the landing gear was not fully retracted before starting — so the automatic hitch feature is blocked.
How do I reset Lippert Leveling System Feature Disabled?
Switch to manual mode and reposition the front to hitch height Exit and re-enter the Hitch Recognition / auto routine Proceed once the front is at or above level
What is the most common cause of Feature Disabled on a Lippert Leveling System?
The most likely cause is landing gear not fully retracted before starting hitch recognition.
Related · Lippert leveling system
The controller's stored level-sensor calibration values are … Comm Error
Communication between the touchpad and the control module ha… Excessive Slope
The RV is parked on ground that is too far out of level for … External Sensor Error
The controller lost a valid reading from the external (rear)… Internal Sensor Error
The level sensor built into the leveling controller itself i… Jack Position Fault
An error at one specific jack on the Ground Control 3.0 elec…
Sources
- Ground Control 3.0 Service Manual — Touch Pad Error Codes — Touch Pad Error Codes, Page 8 (Lippert Components (via ManualsLib))
Note: This message is specific to fifth-wheel Hitch Recognition and does not apply to travel-trailer-only setups.
● Last verified 2026-06-29 · compiled from manufacturer documentation. Codes can vary by model year — always cross-check your unit’s manual.