Go Power Inverter / Charger: “Orange solid (overload/short)”
warning RV inverter fault codes
What it means
Over Load Protection or Short Circuit Protection. While inverting or in AC pass-through, the unit detected an AC overload or output short circuit and shut down. The status LED is solid orange; the alarm sounds five beeps. (Orange slow blink indicates Over Temperature, orange fast blink indicates Under Temperature.)
Most likely causes
- AC load exceeds the inverter's rated output most likely
- High surge load from a motor or compressor at startup common
- Short circuit in AC output wiring or a faulty appliance less common
Safe checks you can do yourself
- Reduce or remove AC loads and turn off non-essential appliances
- Start high-surge appliances one at a time
- Inspect AC output wiring and devices for a short circuit
- Confirm total load is within the unit's wattage rating
How to reset / clear Orange solid (overload/short)
- Reduce or remove the load (or clear the short)
- Turn the inverter back on using the on/off switch on the unit or the remote control
When to call a technician
If the overload/short fault occurs with little or no load, or you suspect a short inside the AC output wiring, stop using the unit and contact a qualified technician.
Applies to
IC-2000-12 · IC-3000-12 · IC Series Inverter/Charger
FAQ
What does Go Power Inverter / Charger code "Orange solid (overload/short)" mean?
Over Load Protection or Short Circuit Protection. While inverting or in AC pass-through, the unit detected an AC overload or output short circuit and shut down. The status LED is solid orange; the alarm sounds five beeps. (Orange slow blink indicates Over Temperature, orange fast blink indicates Under Temperature.)
How do I reset Go Power Inverter / Charger Orange solid (overload/short)?
Reduce or remove the load (or clear the short) Turn the inverter back on using the on/off switch on the unit or the remote control
What is the most common cause of Orange solid (overload/short) on a Go Power Inverter / Charger?
The most likely cause is ac load exceeds the inverter's rated output.
Related · Go Power inverter / charger
Under Voltage Protection / Low Battery. The DC input voltage… Red slow blink (OVP)
Over Voltage Protection. The DC input voltage is above speci…
Sources
- Go Power! IC Series Inverter/Charger Owner's Manual — Status LED Indicator table (Orange = Over Load / Short Circuit Protection); IC Series Fault Conditions (Overload); Beep Counts (5 = Short-circuit/OLP) (Go Power! (GP Electric / Dometic))
Note: Overload/short requires a manual restart via the on/off switch; over-temperature (orange slow blink) instead auto-restarts after cooling.
● Last verified 2026-06-29 · compiled from manufacturer documentation. Codes can vary by model year — always cross-check your unit’s manual.