Lippert Solera Smart Arm 12V power awning fault codes
The 3 fault codes below are the ones that apply to this Lippert awning family. The other 1 Lippert awning codes in our database belong to different model families — they are listed further down so you do not troubleshoot against the wrong table.
Covered model numbers
Solera Smart Arm 12V power awning
Also documented for: Smart Arm assemblies produced after May 2018.
Not on the list? Check the rating label before you troubleshoot — the code table below will not apply. Where to find it →
Fault codes on the Lippert Solera Smart Arm 12V power awning
A Level 1 fault means moisture has been detected in the main 12-pin connector of the Smart… Lock LED blinking — Level 2 fault warning
A Level 2 fault means moisture has been detected in the touchpad or the controller board i… Lock LED blinking — low voltage warning
The Smart Arm controller has detected battery voltage that is too low to safely run the aw…
Codes that do not apply to this model
These 1 codes exist on other Lippert awnings. If your unit is showing one of them, it is not from this family — re-check the model number on the label before acting on any of these.
Where the model number is
On the awning arm casting or the motor housing at the roller end.
Sources
- Solera Awning Smart Arm Owner's Manual — Lippert Components, Inc. (Introduction and Error Codes For Assemblies Produced After May 2018, Form CCD-0001359, Rev 08.22.18)
- Why Is My Lippert Solera Smart Arm RV Awning Blinking Yellow And Will Not Operate? — etrailer.com (Expert Q&A: blinking yellow = Level 2 fault, with unlock sequence)
All Lippert awning fault codes →
Compare awning codes across all brands →
Find another model number →